Regression in 0a11832cd in IDF 5.0.x where macro
CONFIG_ESP_CONSOLE_USB_SERIAL_JTAG_ENABLED is not defined.
With this patch, ESP32-S3 still USB Serial/JTAG incorrectly (now on all
ESP-IDF versions).
Closes#15701
This work was funded through GitHub Sponsors.
Signed-off-by: Angus Gratton <angus@redyak.com.au>
The ESP-IDF default on C3 is primary UART0, secondary USB serial/jtag.
Previously MicroPython configured the primary as USB Serial/JTAG and
manually worked with the UART0 console. However UART0 console stopped
working this way in v5.2.2.
The big change is that CONFIG_ESP_CONSOLE_USB_SERIAL_JTAG is no longer set,
as primary console is UART0. However
CONFIG_ESP_CONSOLE_SECONDARY_USB_SERIAL_JTAG is set and IDF provides a
macro CONFIG_ESP_CONSOLE_USB_SERIAL_JTAG_ENABLED which is set if either
primary or secondary esp_console is USB serial/jtag. So need to use that
macro instead.
This work was funded through GitHub Sponsors.
Signed-off-by: Angus Gratton <angus@redyak.com.au>
This adds named-pins support to the esp32 port, following other ports.
Since the name of esp32 CPU pins is just GPIOx, where x is an integer, the
Pin.cpu dict is not supported and CPU pins are just retrieved via their
existing integer "name" (the cost of adding Pin.cpu is about 800 bytes,
mostly due to the additional qstrs).
What this commit supports is the Pin.board dict and constructing a pin by
names given by a board. These names are defined in a pins.csv file at the
board level. If no such file exists then Pin.board exists but is empty.
As part of this commit, pin and pin IRQ objects are optimised to reduce
their size in flash (by removing their gpio_num_t entry). The net change
in firmware size for this commit is about -132 bytes.
Signed-off-by: Damien George <damien@micropython.org>
